Reproduce “ros2 fanuc interface: Design and Evaluation of a Fanuc CRX Hardware Interface in ROS2” on OpenResearch

Turn your favorite coding agents into research agents that review literature, develop hypotheses, and run experiments.

Universal app for Apple silicon and Intel. Requires macOS 11 or later.

About this paper

Paolo Franceschi, Marco Faroni, Stefano Baraldo, Anna Valente

Researchers from SUPSI and Politecnico di Milano developed and evaluated the first `ros2_control`-compatible hardware interface for the Fanuc CRX collaborative robot series, addressing a gap in the ROS2 ecosystem. This interface enabled full integration with advanced ROS2 tools like `MoveIt2`, demonstrating accurate setpoint reaching and path following capabilities, despite a measured communication latency of approximately 0.31 seconds.

Key insights

  • The chosen Ethernet/IP protocol provides reliable communication but introduces a consistent time delay of approximately 0.31 seconds between command and robot feedback.
  • Fanuc's internal joint and Cartesian velocity limits significantly constrain the robot's dynamic response, causing velocity saturation at higher command frequencies and affecting trajectory tracking accuracy.
  • While real-time closed-loop control is challenging due to latency, the robot demonstrates accurate path following capabilities, particularly for lower frequencies, once time synchronization is considered.

Summary by alphaXiv.

Tip: change arxiv.org to autoarxiv.org in any arXiv abstract link to open the paper here.